Clear
Inkjet Printable Self-Adhesive Vinyl. Sheets 8.5 X 11
|
|
Type |
Inkjet-Printable Clear Vinyl. |
|
Size |
8.5"
X 11" |
|
Printers |
All
Desktop Inkjet Printers |
|
Color |
Clear
(matte finish) |
|
Thickness |
3.5 Mil |
|
Adhesive |
Permanent |
|
Outdoor Life |
Not
recommended for outdoor use |
|
Instructions |
Yes |
|
Tools/Material needed |
None. |
|
Note: |
Indoor use only. |
|
Recommended for indoor use only. If used for temporary outdoor
stickers or temporary bumper stickers you must use clear spray and our Papilio Overlaminate
for protection and UV resistance.
For glossy clear vinyl and textured clear vinyl see other pages here in this
website.
|
|
|
Matte Clear
(Transparent) Inkjet Vinyl
Self Adhesive
10 sheets per pack 8.5" X 11"
Item# IVF8511GC
|
| |
|
Matte Clear
(Transparent) Inkjet Vinyl
Self Adhesive
100 sheets per pack 8.5" X 11"
Item# IVF8511GCKH
|
To order this media please go to
HYAZ
TM Inkjet Media
1) Copy/Print on to the coated side of the media using
a compatible Inkjet Printer.
2) To prevent a paper jam, make sure the vinyl is not bent,
warped, or corners folded BEFORE loading. Loading by hand ONE SHEET at the
time (pressing FF/Ready) is a way to make sure it loads correctly.
3) When gluing a vinyl label to any surface, clean the
surface and remove residual grease, soot, or dust.
4) It is not recommended (on larger labels like 11" X 17")
to remove all the back paper before installing. It’s better to remove the
paper from a small area at one end first such as a 1/2" vertical strip at the
left hand or right hand edge.
5) Line up your label. When the position looks correct, let
the label make contact with the surface on the edge where you removed the back
paper.
6) Now bend the label back and carefully remove the rest of
the protective back paper, and glue the label down working from the end you
glued first. Then work your way towards the other end holding that end away
from the surface. You can use your finger or a sponge and only press down
(glue) a small area each time to prevent trapping air bubbles. Do not use
excessive pressure when working the label to prevent smudging
the ink.
7)
If the label is used outdoors you must use
clear spray and overlaminate. The Overlaminate must
be applied in such way that it prevents water from contacting the label. Clear
enamel spray is available here or in most hardware or automotive parts stores.
You can spray the label before you apply it (after printing)
to prevent over spray. Fixative spray is available in most craft stores or you
can use the clear spray offered here or sold in most automotive parts stores.
Use our WOL overlaminate together with the
spray. Using clear spray as the only protection will
offer limited water proofing.
To extend UV resistant of Inkjet media HPS
offers overlaminate with built in UV barrier.
|
